Zinc Planter Care
These planters are frost resistant when drained properly. We
recommend that you fill the bottom of the pot up with bricks,
stone, gravel or something similar to optimise drainage. To avoid
corrosion on the inside, ensure the drainage hole does not get
blocked; this is best achieved by placing the pot off the ground.
Use good potting compost to ensure optimal drainage. Planters
should also be lined with PVC or bin liner to prevent corrosion
from occuring. Planters must be rinsed on a regular basis to ensure
there is no build of dirt.
In time, UV and weather influences will change the colour and
finish of the product in a natural way. To reduce the speed of
this process you may treat the surface with linseed oil. If a
white sheen appears when the planter is first placed outside linseed
oil can be used to clean the surface. Please use a soft cloth
to clean the planter. In time, steel products are subject to corrosion.
If used indoors, the product must be sealed or placed in a saucer.
To avoid possible problems with condensation on delicate floors
the product must be raised above the floor so air can circulate,
or must be placed on insulation material, for example polystyrene.
Zinc planters are suited to the garden consumer market and not
intended for commercial use.
Gel Burner Care
Placement of the gel burner
-The burner is suitable for Garden, Patio, Conservatory and Large
Living Room.
- Ensure sufficient ventilation is in place without creating a
draft
- After a While the gel burner may create sight staining like
candles
- Make sure the gel burner is placed on a non inflammable, heat
resistant and stable surface
- Ensure that there are no inflammable objects within 2 meters
distance from the gel burner.
User instructions
- Always use the gel burner with the steel gel container supplied
Filling the Steel Gel Container
- While the steel gel container is positioned outside the gel
burner holder, carefully fill the gel container to up 75% of it’s
capacity.
- Remove any burning gel drops spilled onto the gel burner &
container before igniting the gel burner
- Never take out or refuel a hot or warm gel burner
Replacement of the steel gel container
- The steel gel container supplied is fire proof, but must be
replaced if there are any signs of cracks or corrosion.
Usage
- Ignite the gel burner using a long match
- Do not put anything into the flame as this will cause soot,
smoke and fire
- Let the contents of each Gel Container run out and never leave
a burning flame unattended
- Always keep pets and children away from a naked flame
- When using the gel burner outside, please note that a unpredictable
flame can develop
- In case you wish to extinguish the flame before the Gel Container
runs out of gel, cover the flame with the lid, and ensure the
flame is out. Remove the gel container when it has cooled down
and remove the remaining gel
- Do not re-use remaining gel
- Clean the gel container after use by soaking it for about 300
minutes in water and washing up liquid. If required, brush out
the residue and rinse the water. The container is ready for re-use.
Characteristics
- Always follow the instructions shown on the packaging of the
gel.
- The is Gel is flammable liquid, always take care in storage
and keep out reach from children
- In care of swallowing the Gel, immediately contact a doctor
and show the label or packaging of the gel
- The packaging of the gel should be kept away from ignitable
sources
- Do not smoke when lighting the Gel Burner
- The gel for gel burner is best used at room temperature when
used. In temperatures below 10 degrees Celsius the gel will not
ignite easily and it will take more time to for an attractive
flame to develop.
Fibre Terrazzo Care Information
In order to retain the colour apply linseed oil evenly to the
furniture. With a soft cloth, rub the oil in a circular motion
which will embed the oil in the material and will further protect
the furniture.
Recommended for light commercial use.
